Good Start on Welding and Metal Work

Nick spent a half day with Vince today.  Got driver's side fender done, here's a pic of the fender with the patch panel area removed (that's Nick too):

Then here's the finished fender, looks really good.

Vince used the small air powered cutting tool to remove passenger side rear fender arch from donor 1/2 car:

And made the opening for where this will go on the project car.  We left 3/8 inch more material on the project car and will form a flange on the car so the joint overlaps.  If you look real close at the left side of the picture you can see I got a couple of hits in with the flange former.