Installing the windshield with new rubber along the bottom of the frame is one of the toughest jobs on an MGB from our experience. It wasn't easy on this car, but was reasonable. We tried a method we read about using fishing line to hold the rubber in place, we weren't that impressed with this method. Good thing we also did our prior trick of putting a wire inside the rubber extrusion to pull the flap back forward after installation. Turned out real well:
There is a little bit of graying around the edges of the windshield, actually shows up more than in real life in the above picture.
The front headlight buckets and turn signals are installed plus the front bumper:
And the rear bumper is installed:
Things are lining up quite nicely.
No comments:
Post a Comment